What is the distance traveled by the elevator between 8 s and 24 s?
m

The minimum number of overload units for a three-phase AC motor's protection is THREE (3). It is a polyphase motor.

Three-phase motors are polyphase motors, which can be induction motors or synchronous motors.

A three-phase motor is organized to run on three-phase alternating current (AC) electrical power, which is required for diverse industrial devices that use a lot of electrical energy.

These motors (three-phase motor) are composed of a stator (the outer part), a rotor (rotating part), and the enclosure (the external skeleton).

Learn more about three-phase motors here:

https://brainly.com/question/14329442

Answer:

White light is a combination of all colors in the color spectrum.

Explanation:

It has all the colors of the rainbow. Combining primary colors of light like red, blue, and green creates secondary colors: yellow, cyan, and magenta

Answers:

The gravitational potential energy of the diver when he reaches point C is 4410 J.

The velocity of the diver is 9.9 m/s.

Hope you could get an idea from here.

Doubt clarification - use comment section.

[tex]\\ \sf\longmapsto PE=mgh[/tex]

[tex]\\ \sf\longmapsto PE=90(5)(9.8)[/tex]

[tex]\\ \sf\longmapsto PE=4410J[/tex]

Now

It's converted to kinetic energy while reaching ground.

[tex]\\ \sf\longmapsto K.E=4410[/tex]

[tex]\\ \sf\longmapsto \dfrac{1}{2}mv^2=4410[/tex]

[tex]\\ \sf\longmapsto 90v^2=8820[/tex]

[tex]\\ \sf\longmapsto v^2=98[/tex]

[tex]\\ \sf\longmapsto v=9.9m/s[/tex]

Answer:

This will require 266.9 of heat energy.

Explanation:

To calculate the energy required to raise the temperature of any given substance, here's what you require:The mass of the material, m The temperature change that occurs,  ΔT The specific heat capacity of the material,

c

(which you can look up). This is the amount of heat required to raise 1 gram of that substance by 1°C.

Here is a source of values of

c for different substances:

Once you have all that, this is the equation:

Q=m×c×ΔT(Q is usually used to symbolize that heat required in a case like this.)For water, the value of c is 4.186g°C So, Q=750×4.186×85=266=858=266.858

Answer:

it’s the third option: 4,600,000 km

Explanation:

just took the test and that was correct

Answer: frosted glass

Explanation:

Answer:

C

Explanation:

Frosted Glass

Explanation:

Final velocity=Initial velocity+(acceleration×time)

4 ways to find initial velocity:

1) Initial velocity=Final velocity-(acceleration×time)

2) Initial velocity=(Distance/Time)-((acceleration×time)/2)

3) Initial velocity=√Final velocity-(2×(acceleration×distance))

4) Initial velocity=2(distance/time)-Final velocity

Total force = Mass×Acceleration

(F=ma)

Answer:

0.7m/s

Explanation:

According to the conservation of linear momentum, the moment before a collision is equal to the moment after the collision. The equation is written as follows: [tex]m_{a}u_{a} + m_{b}u_{b} = m_{a}v_{a} + m_{b}v_{b}[/tex], where [tex]m[/tex] is the mass of the object, [tex]u[/tex] is the initial velocity, and [tex]v[/tex] is the final velocity.

Let's say the object [tex]a[/tex] is our moving wagon and the object [tex]b[/tex] is our stationary wagon. [tex]m_{a} = 500kg, u_{a} = 1.6ms^{-1}[/tex],  [tex]m_{b} = 3000kg, u_{b} = 0[/tex], since the wagon is stationary, it doesn't have any initial velocity. After collision, the mass remains the same, but the velocity changes: [tex]v_{a} = ?, v_{b} = 1.5ms^{-1}[/tex]

We can observe that [tex]v_{a}[/tex] is what we're looking for according to the question. Now let's substitute our values.

[tex](5000 * 1.6) + (0) = 5000v_{a} + (3000 * 1.5)[/tex]

[tex]v_{a} = \frac{(5000 * 1.6) - (3000*1.5)}{5000}[/tex] = 0.7m/s

Answer:

23: Acceleration 24:1m/s^2

Explanation:

[tex]a = (v_f - v_i) /delta(t)\\a=(16-10)/6\\a=6/6\\a=1m/s^2[/tex]

Answer:

A

Explanation:

Current effiency

= 75/147

= 0.5102

New Efficiency

= 120/100 × 0.5102

= 0.6122

Only option A satisfies this efficiency.

Answer:

The fibers of the sweater lose electrons.

Considering the change of units and the definition of weight, the mass of two washers would be 0.0098 kg and if 4 washers are attached to the string, then the applied force on the car will be 0.196 N.

If each washer has a mass of 4.9 g, then the mass of two washers will be calculated simply by multiplying the mass of 1 washer by the amount you have of them, in this case 2:

4.9 g×2= 9.8 g

Being 1 kg = 1000 g, you apply the following rule of three to make the change of units: if 1000 g equals 1 kg, 9.8 g equals how many kilograms?

[tex]mass=\frac{9.8 gramsx1 kg}{1000g}[/tex]

Solving:

mass= 0.0098 kg

Finally, the mass of two washers would be 0.0098 kg.

On the other side, mass is the amount of matter that a body contains and weight is the action exerted by the force of gravity on the body.

The mass of an object will always be the same, no matter where it is located. Instead, the weight of the object will vary according to the force of gravity acting on it.

Weight is calculated as the product of the object's mass and the value of the gravitational acceleration:

W= m×g

In this case, you know:  

Replacing:

W= 0.0196 kg× 10 m/s²

Solving:

W= 0.196 N

Finally, if 4 washers are attached to the string, then the applied force on the car will be 0.196 N.

Learn more:

Answer:

C, B

Explanation:

Basically your liquid will go over the line because you are adding more mass. the balloon will inflate because  of mass filling it.  Part 1  I noticed that there was a change from the original line.   part 2  Some mass is lost. The bubbles are the gas leaving. The balloon increases in size because of the mass. The cup got heavier when I added the vinegar.

Gas leaving caused the bubbles.

Other than temperature, the property that also has an effect on the rates of chemical reactions is the concentration of the reactants. The correct answer is B

The rate of chemical reaction means how chemical react with respect to time or as a function of time. The rate of chemical reaction tells us the speed or how fast chemicals react.

There are many factors that can affect the rate of chemical reaction. Temperature is one of them. Increase in temperature will increase the rate at which chemical react.

The color of reactants, solubility of reactants and volume of reactants have nothing to do with the rate of chemical reaction.

Other than temperature, the property that also has an effect on the rates of chemical reactions is the concentration of the reactants.

Other factors affecting the rate of chemical reaction are:

Therefore, the correct answer is option B

Learn more about chemical reaction here: https://brainly.com/question/11231920?source=archive

The average velocity of the car for the whole journey is 69.57 km/h.

The given parameters:

The time spent by the before refueling is calculated as follows;

[tex]t = \frac{d}{v} \\\\t_1 = \frac{240}{75} \\\\t_1 = 3.2 \ hours[/tex]

The time spent by the car for the remaining journey;

[tex]t_3 = \frac{320 - 240}{100} \\\\t_3 = 0.8 \ hr[/tex]

The total time of the journey is calculated as follows;

[tex]t = t_1 + t_2 + t_3\\\\t = 3.2 \ hr \ + \ 0.6 \ hr \ + \ 0.8 \ hr\\\\t = 4.6 \ hours[/tex]

The average velocity of the car for the whole journey is calculated as follows;

[tex]v = \frac{total \ distance }{total \ time} \\\\v = \frac{320}{4.6} \\\\v = 69.57 \ km/h[/tex]

Learn more about average velocity here: https://brainly.com/question/6504879

Answer:

answer to this question is c

Answer:

3

Explanation:

because the battery's power is not functioning well

Answer:

it will float up cause its has gravity

When Jacob cuts some holes in the disk and immerses it again in a vessel of water it will now float at the top. Thus, the correct option for this question is A.

An object floats when the weight force on the object is balanced by the upward push of the water on the object. The upwards push of the water increases with the volume of the object that is underwater. It is not affected by the depth of the water or the amount of water.

According to the context of this question, when a disk does not have holes in it, it will definitely sink to the bottom of the water because it has high density, but when the hole is made in the disk, the water is passed out from them and now, the upward force is minimized that cause less density as compared to previous.

Therefore, when Jacob cuts some holes in the disk and immerses it again in a vessel of water it will now float at the top. Thus, the correct option for this question is A.

To learn more about Upward force, refer to the link:

https://brainly.com/question/24279743

#SPJ2

Answer:

gravitational force

...........

Answer:

a seat

Explanation:

The phrase “seat value” is used in the hospitality and bar sectors to describe how much money each seat or square foot of customer area must generate to justify its existence.

An area to sit is a seat. The phrase may also refer to headquarters in a more general meaning as well as extra elements such a back, armrest, and head restraint.

Being in the centre allows you to benefit from both the advantages of both front and back seating while balancing out their extremes. While you're still close enough to be paying careful attention to the lecture, the middle rows will relieve you of the pressure and expectations of the front.

By remaining seated, students help avoid physical altercations. There is more time spent on task when pupils are seated.

Environmental psychology, which gives people the impression that they have some degree of influence over their daily lives, is the driving force behind all of this behavior.

Therefore, seat used by people.

Learn more about seat here:

https://brainly.com/question/19261993

#SPJ2

The approximate length of the arc intersected by the central angle is 20.94 inches.

The given parameters:

The approximate length of the arc intersected by the central angle is calculated as follows;

S = rθ

where;

Substitute the given parameters and solve for the length of the arc

[tex]S = 10 \ in \times \frac{2\pi }{3} \\\\S = 20.94 \ inches[/tex]

Thus, the approximate length of the arc intersected by the central angle is 20.94 inches.

Your question is not complete, find the complete question below:

A circle has a radius of 10 inches. Find the approximate length of the arc intersected by a central angle of [tex]\frac{2\pi}{3}[/tex].

Learn more about length of arc here: https://brainly.com/question/2005046

Suns' gravitational pull​ prevents the planets in our solar system from floating away, therefore the correct answer is option D.

It is a structure in which the sun's attractive force causes all the planetary systems and celestial bodies to revolve around this.

The Sun is believed to be located in the system's center in the sun-centered concept upon which our Solar System is founded.

The primary factor that causes the planets in the solar system to revolve around the sun is gravity.

The sun's pull of gravity prohibits the planets in our planetary system from moving away, hence option D is the appropriate

To learn more about Solar systems, refer to the link given below;

brainly.com/question/12075871

#SPJ2

v = d/t

= 400/25

= 16 m/s

I'm not sure though

Answer:

bugs/viruses all the time and more social platforms

Explanation:

[tex]\\ \sf\longmapsto F=\dfrac{Gm_1m_2}{r^2}[/tex]

[tex]\\ \sf\longmapsto F=\dfrac{Gm^2}{r^2}[/tex]

[tex]\\ \sf\longmapsto G=\dfrac{Fr^2}{m^2}[/tex]

SI units:-

[tex]\\ \sf\longmapsto G=\dfrac{Nm^2}{kg^2}[/tex]

Option C is correct

Answer:

56 proton sir

have a nice day

Answer:

The anomalous expansion of water is an abnormal property of water whereby it expands instead of contracting when the temperature goes from 4o C to 0o C, and it becomes less dense. The density is maximum at 4 degree centigrade and decreases below that temperature as shown in graph.

Explanation:do you want me to explain it more??

Answer: 250n

Explanation:

The formula for gravitational force is: F = (gMm)/r^2

There are two factors at play here:

1) The mass of the planet 'M'

2) The radius 'r'

We can ignore the small M and the g, they are constants that do not alter the outcome of this question.

You can see that both M and r are double that of earth. So lets say earth has M=1 and r=1. Then, new planet would have M=2 and r=2. Let's sub these two sets into the equation:

Earth. F =  M/r^2 = 1/1

New planet. F = M/r^2 = 2/4 = 1/2

So you can see that the force on the new planet is half of that felt on Earth.

The question tells us that the force on earth is 500n for this person, so then on the new planet it would be half! So, 250n!

Answer:

C is the right answer for the question

Answer:

refraction

Explanation:

but this is easy so why